Beading for front and rear bumper end caps, 911 (65-73) + 912 (66-69)

Our beading for front and rear bumper end caps is used in the following vehicles as original equipment:

This beading is used as a finishing seal for the front bumper end caps in the following vehicles:

Porsche 911 S 2.0 L (1969)          

Porsche 911 T 2.0 L (1969)

Porsche 911 L 2.0 L (1969)          

Porsche 911 E 2.0 L (1969)          

Porsche 912 1.6 L (1969)

Porsche 911 T 2.2 L (1970-1971)  

Porsche 911 E 2.2 L (1970-1971)            

Porsche 911 E 2.4 L (1972-1973)            

Porsche 911 S 2.2 L (1970-1971)

Porsche 911 S 2.4 L (1972-1973)           

Porsche 911 TV 2.4 L (1972-1973)          

Porsche 911 TE 2.4 L (1972-1973)                             

Porsche 911 TK 2.4 L (USA-CAN) (1973)                                       

Porsche 911 Carrera 2.7 L (1973) Engine Type 911.83

For this application approximately 11 inches (260 mm) of beading are required per side.

Quantity required per vehicle in this application: 2

This beading is also used as a finishing seal for the rear bumper end caps in the following vehicles:

Porsche 911 2.0 L (1965-1968)              

Porsche 911 S 2.0 L (1967-1969)  

Porsche 911 T 2.0 L (1968-1969)

Porsche 911 TU 2.0 L (1968)

Porsche 911 L 2.0 L (1968-1969)            

Porsche 911 E 2.0 L (1969)          

Porsche 912 1.6 L (1966-1969)

Porsche 911 T 2.2 L (1970-1971)  

Porsche 911 E 2.2 L (1970-1971)            

Porsche 911 E 2.4 L (1972-1973)            

Porsche 911 S 2.2 L (1970-1971)

Porsche 911 S 2.4 L (1972-1973)           

Porsche 911 TV 2.4 L (1972-1973)          

Porsche 911 TE 2.4 L (1972-1973)                             

Porsche 911 TK 2.4 L (USA-CAN) (1973)

This beading is not used in the 911 Carrera 2.7 L.

For this application approximately 11 inches (260 mm) of beading are required per side.

Quantity required per vehicle in this application: 2

This beading is placed between the front and rear bumper ends and their chromed bumper caps.

Note: this beading is sold by the meter.

For the upkeep or restoration of your 911 or 912 bumper ends we also have the following references available:

911.080193: Front bumper end cap, left side, 911 (69-73)

911.080194: Front bumper end cap, right side, 911 (69-73)

911.080197: Rear bumper end cap, left side, 911 T + 911 E + 911 S (69-73)

911.080198: Rear bumper end cap, right side, 911 T + 911 E + 911 S (69-73)