Clutch release fork shaft, early type, G50 transmission, 911 (87-89) + 911 Turbo (89)

      Porsche 911 Carrera 3.2 L (1987-1989)

      Porsche 911 Carrera 3.2 L Turbo-Look (1987-1989)

      Porsche 911 Turbo 3.3 L with Type G50 5-speed transmission (1989) *

Notes:

* For vehicles equipped with a Type G50 5-speed transmission up to the following transmission numbers:

- 911 Turbo 3.3 L: >> G 5050 1K00694 (1989)

- 911 Turbo 3.3 L with 40 % limited-slip differential: >> G 5050 2K00538 (1989)

This clutch release fork shaft is the one that was installed on the first G50 Type gearboxes from the 1987 year-model onwards.

Quantity required per vehicle: 1

This early type fork shaft is no longer available from the Porsche factory, as it has been replaced by a newer design. However with our part you can still use the early type clutch release fork if your vehicle is so equipped.

During a clutch replacement for instance, check the condition of your early style clutch release fork and replace its shaft with our part. To rebuild your early clutch release fork shaft you will also need to order the 2 16 x 22 x 20 mm. needle cage clutch fork bearings available under reference 911.030038A2.

(For the later model Porsche 911 Carrera’s from 1987-1989 and the later 911 Turbo’s from 1989, this procedure no longer applies, as the early clutch release fork shaft has been replaced by the later-model clutch release fork shaft reference 911.030038A.)

Double-check the release fork shaft style on your vehicle before placing your order.