Decorative moulding (wide trim) for left/right rear bumper half, 911 S (67-68)

Our decorative moulding with wide trim for the left and right rear bumper halves is suitable for the following vehicles (Coupé and Targa versions):

Porsche 911 S 2.0 L (1967-1968)  

Porsche 911 S Targa (1967-1968)

This rear bumper moulding with a wide trim can be installed either on the left or right rear bumper half. It is made up of a chromed base with a raised wide rubber strip.

This rear bumper moulding with a wide trim is fastened to each rear bumper half with four M5 locknuts, four M5 plastic washers and four T-shaped screws reference 911.080159.  

Quantity required per vehicle: 1

Note: this part is sold individually.

To carry out the restoration of the left or right rear bumper on your 911, we also have the following references available:

911.080079: Rear bumper half, left side, 911 (65-68) + 912 (66-68)

911.080080: Rear bumper half, right side, 911 (65-68) + 912 (66-68)

911.080156: Front and rear bumper guard seal, 911 (65-73) + 912 (66-69)

911.080159: T-shaped screw, M5, for front and rear bumper mouldings with wide trim 911 (67-73) + 912 (69)

911.080186: Rear bumper guard with no rubber pad,  911 (65-68) + 912 (66-68)

911.080187: Rear bumper guard with rubber pad,  911 (69-73) + 912 (69)

911.080187B: Plastic plug for chassis side member and rear bumper 912 + 911 (65-73)

911.080187C: Rubber protection pad for rear bumper guard, 911 (69-73) + 912 (69)