Elbow-shaped hot air exit pipe 911 (75-89, on Left /Right heat exchanger) + 964 Turbo

Our elbow-shaped hot air exit pipe is used in the following vehicles (quantities required per vehicle are given in parentheses):

- On the Left and Right heat exchangers:

Porsche 911 2.7 L (1975-1977) (2)         

Porsche 911 S 2.7 L (1974-1977) (2)

Porsche 911 S Carrera 2.7 L (1975) (USA-CAN)   (2)

Porsche 911 S Carrera 2.7 L (1975) (Version for California) (2)

Porsche 911 Carrera 2.7 L (1974-1976) (2)                          

Porsche 911 Carrera 3.0 L (1976-1977) (2)        

Porsche 911 SC 3.0 L (1978-1983) (2)

Porsche 911 SC 3.0 L Sportomatic (1978-1980) (2)

- On the Right heat exchanger:

Porsche 911 Turbo 3.0 L Type 930 (1975-1977)* (1)

Porsche 911 Turbo Carrera (USA-CAN) 3.0 L (1975-1977)** (1)

Porsche 911 Turbo 3.3 L Type 930 (1978-1989) (1)

* except for the 930 Turbo 3.0 L (Japan) from 75-77 equipped with thermal reactors.

** except for the 930 Turbo Carrera 3.0 L (USA) from 76-77 equipped with thermal reactors.

This elbow-shaped metal pipe is also used as an adapter on the hot air piping leading to the rear right blower motor in the following vehicles:

Porsche 964 Turbo 3.3 L (1991-1992) (1) 

         Porsche 964 Turbo 3.6 L Type 965 (1993-1994) (1)

Note: this part is sold separately.

During the replacement of the elbow-shaped pipes on your heat exchangers, you should check the condition (and replace if necessary) the following components:

911.010522: Heat exchanger to engine shroud heater hose, 911 (65-74) + 911 Turbo (75-89) (2)

911.010523: Aluminum hot air hose, left side, 911 (75-83)

911.010523A: Brown hot air tube, left side, 911 Turbo (75-92)

911.010524: Brown hot air tube to blower motor, left side, 911 (75-83) + 914-6 (70-72)

911.010530: Connecting air hose clamp 50x70 mm. (4)