Front bumper moulding with wide trim 911 S (67-73) + 911 E (69-73)

Our front bumper moulding with wide trim is used in the following vehicles in their Coupé and Targa versions:

Porsche 911 S 2.0 L (1967-1969)  

Porsche 911 E 2.0 L (1969)          

Porsche 911 E 2.2 L (1970-1971)            

Porsche 911 E 2.4 L (1972-1973)            

Porsche 911 S 2.2 L (1970-1971)

Porsche 911 S 2.4 L (1972-1973)           

Porsche 911 S Targa (1967-1969)

Porsche 911 E Targa (1969)

Porsche 911 E Targa (1970-1973)

Porsche 911 S Targa (1970-1973)

This front bumper moulding with a wide trim is made up of a chromed base with a raised wide rubber strip.

This front bumper molding with a wide trim is fastened to the front bumper with 8 T-shaped screws reference 911.080159, 8 M5 locknuts and 8 M5 washers with an internal diameter of 5.3 mm. reference 911.100020.

Quantity required per vehicle: 1

Note: this part is sold individually.

To carry out the restoration of the front bumper on your 911 E or 912 S, we also have the following references available:

911.080154: Front bumper guard with rubber pad, left, 911 S (67-73) + 911 E (69-73)

911.080155: Front bumper guard with rubber pad, right, 911 S (67-73) + 911 E (69-73)

911.080155C: Rubber protection pad for front bumper guard, 911 S (67-73) + 911 T (68-73) + 911 E (69-73)

911.080156: Front and rear bumper guard seal, 911 (65-73) + 912 (66-69)

911.080158A: Wide rubber protection strip for front bumper moulding 911 S (67-73) + 911 E (69-73)

911.080159: T-shaped screw, M5, for wide front and rear bumper mouldings 911 (67-73) + 912 (69)

911.100020: Washer, diam. 5.3 mm.