Gasket between intake pipes and throttle valve housing 911 MFI E/S/T-E (70-73) + 911 Carrera 2.7L

Our gasket between the intake pipes and throttle valve housing is suitable for the following vehicles equipped with a mechanical fuel injection (MFI) system:

Porsche 911 E 2.2 L (1970-1971)   

Porsche 911 E 2.4 L (1972-1973)   

Porsche 911 S 2.2 L (1970-1971)  

Porsche 911 S 2.4 L (1972-1973)  

Porsche 911 S 2.4 L with Sportomatic transmission (1973)      

Porsche 911 T-E 2.4 L (USA-CAN) (1972-1973)

Porsche 911 Carrera Coupé (2.7 L) (1973)

Porsche 911 Carrera 2.7 L (1974-1976)   

These intake pipes / throttle housing gaskets ensure that there are no air leaks between the intake pipes and the throttle housing bodies which could alter the proper air metering to the combustion chamber and affect the correct air to fuel ratio at different throttle settings. Defective intake gaskets could alter the proper (stoïchometric) balance between air and fuel in the combustion chamber and reduce engine performance. 

For the fuel injected versions of the 911, these intake gaskets are located below the intake manifold pipes (also known as intake suction pipes or velocity stacks) and the throttle valve housing.

Quantities required per vehicle: 6

Note: This part is sold individually, unless it is included in one of our engine seal and gasket sets.

When replacing the intake pipe to throttle housing gaskets on your fuel-injected 911, it is advisable to also check the integrity (and replace if necessary) the following components:

Intake gasket, throttle housing to cylinder head, reference  911.010380 (6 gaskets required per vehicle).