Intake manifold gasket for 40 mm. carburetor

Our intake manifold gasket was factory equipment on the following vehicles that were equipped with the 40 mm. Weber carburetor:

Porsche 911 S 2.0 L (1969)          

Porsche 911 E 2.0 L (1969)

These intake manifold gaskets ensure that there are no leaks between the carburetors and the intake manifolds below them.

These intake manifold gaskets are used on the following 40 mm. Weber carburetors:

         IDA  (911 + 911 L 66-68 / 911 S 67 up to engine number M096 0502)

         IDS (911 S 68 from engine number M096 0503)

         IDT (911 TU 68)

         IDTP (911 T 69)

These intake manifold gaskets are also suitable however for the 40 mm. PMO carburetors, reference 911.1420040K.

Quantities required per vehicle: 6

Note: This part is sold individually, unless it is included in one of our engine seal and gasket sets.

When replacing the intake manifold gaskets on your carbureted 911, it is advisable to also check the integrity (and replace if necessary) the following components:

Intake gasket, reference 911.010379 or 911.010380 (6 gaskets required per vehicle).