Rocker panel moulding (wide trim) 911 L (USA-1968) + 911 S (67-68)

Our rocker panel moulding with wide trim is suitable for the following vehicles in their Coupé and Targa versions:

Porsche 911 S 2.0 L (1967-1968)  

Porsche 911 L 2.0 L (1968-1969) (USA) ¹ 

Porsche 911 S Targa (1967-1968)

Note:

¹ Version of the 911 L for Europe and the rest of the world uses rocker panel moulding reference 911.080171.

This moulding is fastened to the left and right-side lower rocker panels under the door sill. It is made up of a wide chromed base with a raised narrow rubber strip.

This rocker panel moulding with a wide trim is fastened the left and right rocker panel with five self-tapping screws reference 911.080173 each.

Quantity required per vehicle: 1

Note: this part is sold individually.

To carry out the restoration of the left or right rocker panel on your 911, we also have the following references available:

911.080173: M3.5 x 16 mm. self-tapping screw

N911.080201:  Decorative seal on upper edge of rocker panel moulding (wide trim) 911 L (USA-1968) + 911 S (67-68)

911.080199: Rocker panel end cap, left front, 911 (67-73)

911.080199A: Rocker panel end cap, left rear, 911 (67-73)

911.080200: Rocker panel end cap, right front, 911 (67-73)

911.080200A: Rocker panel end cap, right rear, 911 (67-73)