Rocker panel / running board trim, right, 911/911 S 2.7 L (74-77) + 911 Turbo Slant Nose (88-89)

Our right-side rocker panel cover or trim in black finish is suitable for installation in the following vehicles in their respective Coupé, Targa and Cabriolet versions:

Porsche 911 2.7 L (1974-1977)     

Porsche 911 S 2.7 L (1974-1975)  

Porsche 911 S 2.7 L (1976) (USA-CAN-California-Japan)

Porsche 911 S 2.7 L (1977) (USA-CAN-Japan)

Porsche 911 Turbo 3.3 L Type 930 Slant Nose M506 (1988-1989)

Notes:

This right rocker panel cover is not useable on the 911 Turbo from 1975 to 1987; however it is factory-installed on the Porsche 930 Turbo « Slant Nose » from 1988 to 1989.

This rocker panel trim is also offered by Porsche with a chromed finish for the 911 and the 911 S from 1974 to 1977.

Quantity required per vehicle: 1

Note: this part is sold individually.

To carry out the restoration of the left or right rear rocker panel area on your 911, we also have the following references available:

911.080225: Rocker panel / running board trim, left, 911/911 S 2.7 L (74-77) + 911 Turbo Slant Nose (88-89)

911.080314: Plastic jack hole plug on lower rocker panel trim, 911/911 Turbo (74-89) + 959

911.080328: Rubber insert for lower rocker panel cover, 911/911 Turbo (74-89)

911.080332: End cap for rocker panel cover (2 pieces) 911/911 Turbo (74-89)

911.080332A: Front left + rear right end cap for rocker panel cover, 911/911 Turbo (74-89)

911.080332B: Front right + rear left end cap for rocker panel cover trim, 911/911 Turbo (74-89)