Seal for the clutch release bearing fork shaft, 911 (72-86) + 911 Turbo (75-77)

Our rubber seal for the clutch release fork shaft is used as original equipment on the following vehicle models that are equipped with a Type 915 or 930 manual transmission:

      Porsche 911 E / 911 S 2.4 L (1972-1973)

      Porsche 911 T-V / 911 T-E / 911 T-K 2.4 L (1972-1973)

      Porsche 911 Carrera 2.7 L (1973-1975)

      Porsche 911 2.7 L (1974-1977)

      Porsche 911 S 2.7 L (1974-1977)

      Porsche 911 Carrera 3.0 L (1976-1977)

      Porsche 911 SC 3.0 L (1978-1983)

      Porsche 911 Carrera 3.2 L (1984-1986)

      Porsche 911 Carrera 3.2 L Turbo-Look (1984-1986)

      Porsche 911 Turbo 3.0 L (1975-1977)

Notes:

This rubber seal is located at the bottom end of the upright shaft for the clutch release bearing fork where the shaft connects with the clutch release fork control lever. This seal sits on top of the control lever and prevents play between the fork’s upright shaft and control lever.

Not for use on vehicles equipped with Sportomatic transmissions.

Quantity required per vehicle: 1 or as required for proper fit of the clutch release bearing fork shaft during transmission assembly.