T-shaped screw, M5, for wide front and rear bumper mouldings 911 (67-73) + 912 (69)

Our T-shaped screw is used as original equipment for fastening the wide front and rear bumper mouldings in the following vehicles in their Coupé and Targa versions:

Porsche 911 S Coupé 2.0 L (1967-1969)  

Porsche 911 S Targa 2.0 L (1967-1969)

Porsche 911 S 2.2 L Coupé (1970-1971)

Porsche 911 S 2.2 L Targa (1970-1971)

Porsche 911 S 2.4 L Coupé (1972-1973)  

Porsche 911 S 2.4 L Targa (1972-1973)   

Porsche 911 E Coupé 2.0 L (1969) 

Porsche 911 E Targa 2.0 L (1969)

Porsche 911 E 2.2 L Coupé (1970-1971)   

Porsche 911 E 2.2 L Targa (1970-1971)   

Porsche 911 E 2.4 L Coupé (1972-1973)

Porsche 911 E 2.4 L Targa (1972-1973)

This M-5 T-shaped screw is used on vehicles with wide so-called Type S front and rear bumper mouldings that are installed on the 911 S and 911 E from 1967 to 1973.

This T-shaped screw is not suitable to fasten the front and rear bumper mouldings with narrow trim that are used on the 912 and the Porsche 911, 911 L and 911 T from 1965 to 1973.

Quantities required per vehicle:

- to fasten the wide front bumper mouldings: 8

- to fasten the wide rear bumper mouldings: 4 for each rear bumper trim.  Total : 16

The head of the T-shaped screw is placed inside the moulding inside rail and the shank is fastened on the other side of the bumper with an M5 washer and locknut.

Note: this part is sold individually.

To carry out the restoration of the front or right bumper mouldings on your 911 S or 911 E, we also have the following references available:

911.080158: S-Type front fender trim, wide, 911 E (69-73) + 911 S (67-73)

911.080158A: Rubber insert, wide, for S-Type front fender trim, 911 E (69-73) + 911 S (67-73)

911.080184: Decorative moulding (wide trim) for left/right rear bumper half, 911 S (67-68) 

911.080185: Decorative moulding (wide trim) for left/right rear bumper half, 911 E (69-73) + 911 S (69-73)

911.100020: Washer, diam. 5.3 mm.